The factory audio system in a lot of Acura’s lacks overall volume. This lack of volume is often the result of a faulty amplifier or cheap components used from the factory. Our plug and play amplifiers offer different upgrade options without having to upgrade your speakers or factory radio. This amplifier is manufactured by MB Quart and is used to power each speaker or speakers with a maximum of 80Watts. The factory amplifier in your Acura powers each speaker with 20W RMS. This new amplifier can quadruple the amount of power going to each individual speaker resulting in a much louder factory system. The amplifier can be used with factory speakers or aftermarket speakers. The amplifier comes configured so it does not damage your factory speakers it just allows them to be louder. This amplifier is a true plug and play installation it does not require any new power or ground lines. All you have to do to install the amplifier is disconnect and remove the factory amplifier then plug this one in with the corresponding connectors for your Acura. There is no wire splicing or cutting required. The final step to install the amplifier is to mount it using the provided hardware.
The MB Quart amplifier is a great choice for systems where you will add an additional subwoofer and amplifier for low end bass or for vehicles with 6 or 8 regular speakers. If your Acura has a factory amplifier that powers your speakers, subwoofer and center channel this upgrade will result in the loss of the center channel and the subwoofer. This means the speaker on your dashboard will no longer produce sound and your subwoofer will no longer produce sound. If you are unsure of what speakers will receive an upgrade and which speakers you will be lost feel free to send us a message and we can help you figure out which option is the best for you. If your vehicle has eight or six individual drivers this amplifier will work great. An example of a vehicle with 8 individual drivers is a 2004-2008 Acura TSX. This amplifier is configured to power all of the speakers in the car without an issue. Another example is a 2007-2009 Acura MDX with 8 speakers that can be powered by this amplifier.
The MB Quart specifications are as follows. The pioneer amplifier can handle loads of 2ohms to 4ohms on each individual channel. The pioneer amplifier can be bridged on the front or rear channels with a loads that have a final impedance of 4ohms. The amplifier is equipped with built high pass and low pass filters but the frequency or slope is not specified. The amplifier has a frequency response of 20hz to 20Khz. The amplifier requires at maximum of 30A amps of power that is protected with an inline fuse. The amplifier is rated for 80 watts maximum at 2ohms and 40 watts at 4ohms. This amplifier is equipped with manual gain matching from .2v to 9v.